•Set contents:---

 15 x 19mm Flat Reamer for Universal injector,

 17 x 19mm Flat Reamer for Bosch injectors (Mercedes CRD).

 17 x 17mm Flat Reamer for Delphi / Bosch injectors (BMW/PSA/Renault/Ford). 

 17 x 21mm Angled Resmer for Fiat / Iveco,

 T Handle x 1.

 Pilot post x 1. 

•Using the T bar and socket supplied apply only a small amount of pressure whilst turning the cutter in a clockwise direction only. Identify injector " Blow-By " exists. Gain access to the injectors and remove them. Material:：CR-V.

•Select required reamer onto pilot post and tighten internal hex screw. Place assembled cutter into injector recess.

•Use a small amount of light lubricant whilst performing the cut to reduce chattering and help give a flat cut. 

•Fit injectors as per manufacturers instructions. Thoroughly clean the seat and remove all swarf. 

•DO NOT over cut the seat only remove enough metal to form a good seat.

•Set contents:---

 15 x 19mm Flat Reamer for Universal injector,

 17 x 19mm Flat Reamer for Bosch injectors (Mercedes CRD).

 17 x 17mm Flat Reamer for Delphi / Bosch injectors (BMW/PSA/Renault/Ford). 

 17 x 21mm Angled Resmer for Fiat / Iveco,

 T Handle x 1.

 Pilot post x 1. 

•Using the T bar and socket supplied apply only a small amount of pressure whilst turning the cutter in a clockwise direction only. Identify injector " Blow-By " exists. Gain access to the injectors and remove them. Material: CR-V.

•Select required reamer onto pilot post and tighten internal hex screw. Place assembled cutter into injector recess.

•Use a small amount of light lubricant whilst performing the cut to reduce chattering and help give a flat cut. 

•Fit injectors as per manufacturers instructions. Thoroughly clean the seat and remove all swarf. 

•DO NOT over cut the seat only remove enough metal to form a good seat.