•For use on Audi, Citroen, Peugeot, VW and Volvo diesel and petrol engined cars & light commercial vehicles.
•After use, remove all setting pins and locking plates.
•Turn the engine over twice by hand to complete a full cycle. Regain T.D.C. (Top Dead Center) & insert setting tools to re-check the alignment is correct.
•Remover setting tools and check there is no obstruction, by turning the engine over twice by and again, to complete a full cycle.

•For use on Audi, Citroen, Peugeot, VW and Volvo diesel and petrol engined cars & light commercial vehicles.
•After use, remove all setting pins and locking plates.
•Turn the engine over twice by hand to complete a full cycle. Regain T.D.C. (Top Dead Center) & insert setting tools to re-check the alignment is correct.
•Remover setting tools and check there is no obstruction, by turning the engine over twice by and again, to complete a full cycle.