• Puller for Injection Pump Tool Kit
  Applicable for BMW 4 cylinder diesel engine (M41), 6 cylinder diesel
  engine - 2.5 (M51) also for Opel/Vauxhall Omega 2.5 TD.
  To loosen the injection pump pulley from the shaft when dismounting
  the injection pump.

• Injection Pump Extractor Tool Kit
  To lock the injection pump sprock in position and press out the injection
  pump shaft.
  This tool is required when removing the injection pump.
  Note: Only item 1 is used on M47 engine. Item 1 and 2 are both used
            on M47TU, M57 and M57TU engines.

• Mercedes Benz Guide Rail Pin Puller
  Can remove even the most stubborn pins from the cylinder head, unlike
  the short slide hammer previously used to attempt this job.
  This puller incorporates a thrust bearing to ease the pulling action.
  The overall length is 85 mm which allows it to fit into those tight problem area.

• Puller for Injection Pump Tool Kit
  Applicable for BMW 4 cylinder diesel engine (M41), 6 cylinder diesel
  engine - 2.5 (M51) also for Opel/Vauxhall Omega 2.5 TD.
  To loosen the injection pump pulley from the shaft when dismounting
  the injection pump.

• Injection Pump Extractor Tool Kit
  To lock the injection pump sprock in position and press out the injection
  pump shaft.
  This tool is required when removing the injection pump.
  Note: Only item 1 is used on M47 engine. Item 1 and 2 are both used
            on M47TU, M57 and M57TU engines.

• Mercedes Benz Guide Rail Pin Puller
  Can remove even the most stubborn pins from the cylinder head, unlike
  the short slide hammer previously used to attempt this job.
  This puller incorporates a thrust bearing to ease the pulling action.
  The overall length is 85 mm which allows it to fit into those tight problem area.