• The adaptor is designed to take off the front hubs found on the
  3/4 ton (2500 series) and 1 ton (3500 series) Dodge pick up trucks.
• The adaptor was designed to cut the flat rate for changing out U-joints,
  front differential service, ball joints and any front hub service.
• The adaptor works on both 6-PT fasteners fro newer models and
  12-PT fasteners found on older Dodge trucks.

• Step 1: Use socket and ratchet to loosen the four hub bolts.
  Just back the bolts out about a quarter inch (need them to press the
  hub out of the knuckle).
• Step 2: Place the adaptor over hub bolt. Turn steering knuckle
  assembly to hold free end of the adaptor in place against axle bracket.
  Apply pressure by turnung steering wheel.

• The adaptor is designed to take off the front hubs found on the
  3/4 ton (2500 series) and 1 ton (3500 series) Dodge pick up trucks.
• The adaptor was designed to cut the flat rate for changing out U-joints,
  front differential service, ball joints and any front hub service.
• The adaptor works on both 6-PT fasteners fro newer models and
  12-PT fasteners found on older Dodge trucks.

• Step 1: Use socket and ratchet to loosen the four hub bolts.
  Just back the bolts out about a quarter inch (need them to press the
  hub out of the knuckle).
• Step 2: Place the adaptor over hub bolt. Turn steering knuckle
  assembly to hold free end of the adaptor in place against axle bracket.
  Apply pressure by turnung steering wheel.